Aerial Lift Exam

Transportation devices, such as scissor lifts, may be used for transporting personnel as long as personal protective equipment (PPE) is utilized.

Electrical lines can be considered 'dead' when verified by

Company operations shall conform to the High Voltage Proximity Act, which applies to electrical systems carrying 600 volts or more and requires employers to:

The operator shall understand all warnings and instructions listed in the manual and on the equipment.

The pre-use inspections are not mandatory if the operator has been familiarized and certified on the specific model aerial lift equipment.

Only critical operation levels and controls need to have marks that are readable and understandable.

Which of the following is NOT a common hazard associated with operating aerial lifts?

Overloading the basket or platform can cause which of the following problems?

When workers are required to routinely work in the proximity of energized electrical lines in an aerial lift piece of equipment they must receive annual training with regards to precautions for high voltage electricity.

Anchorage is a condition of a mobile unit in which the sum of the movements tending to overturn the unit is equal to or exceeds the sum of the movements tending to resist overturning.

When working in a bucket or basket of a vehicle mounted, rotating or articulating aerial device a fall protection harness/body belt is mandatory.

If the lift does not elevate high enough to reach the intended work area the worker is allowed to do which of the following?

How often must the user of the fall protection equipment inspect the equipment?

Which of the following are signs of damage to web lanyards?

In addition to daily use inspections of fall protection equipment must be inspected by a qualified person on a yearly basis.

Modification may be made to any aerial lift device with written approval of the company and manufacturer.

Lift controls shall be tested each day prior to use to determine that such controls are in safe working condition.

Only trained persons shall operate an aerial lift.

Aerial work platforms should not be raised under which of the following conditions

Which of the following personnel are qualified to conduct an annual inspection on an aerial lift piece of equipment?

Which of the following are types of inspections conducted on elevating work platforms?

Before an operator is allowed to use an aerial lift platform the employer must ensure that the employee has received familiarization training on the specific lift to be used that includes which of the following?

Which of the following controls has the feature of allowing it to override the other set of controls

All aerial lift platforms must have a guardrail system consisting of a top rail, mid rails and toe boards.

Which of the following is the typical maximum slope that an elevating work platform will be rated to operate at?

Which of the following is responsible for verifying overhead electrical line voltage, verifying overhead electrical lines are dead and participating in training for agencies that work in the proximity of energized overhead electrical lines?

When chocking the wheels prior to starting operation it is sufficient to place only one wheel chock behind one wheel in the direction you expect the vehicle to roll.

It is acceptable practice to allow the vehicle to travel while the boom is elevated as long as the vehicle does not exceed 5 mph.

Which of the following would be considered an unsafe work practice?

When can lower level controls be used to override upper level controls?

Why must modifications to equipment required to be certified by the manufacture or equivalent entity?

Preparation for over the road travel with a vehicle mounted aerial device consists of which of the following?

Vehicle mounted aerial devices are divided into two main categories, articulating boom aerial devices and extendible boom aerial devices.

Vehicle mounted aerial devices are classified into insulated and non-insulated in accordance with their rating after being tested for conductance of electricity.

The clearance for work near energized electrical lines with boom extended or elevated is